Saturday, October 25, 2008

Pokemon Roms Source For Cydia

Practice 1: STUDY OF THE PROPERTIES OF SUBSTANCES. (Theme 1: Connections between atoms.)

SUMMARY:
Our work has been carried out in order to check and observe some of the properties of substances, both ionic and covalent (molecular and atomic) and metal. We did it in the laboratory for Physics and Chemistry d school for two days because it was not a pr Acetic short.
substances we have discussed were: NaCl (sodium chloride or salt) , H2O (water) , I2 (Iodine) , C (graphite) and Cu (copper filings e) . The conductivity experiment also use what at first would pentane, but we could not get (we used benzene instead.)
These substances can be found in nature, have been subjected to various tests that we have shown
do: their different thermal stabilities, for qu and we heated the substances for the space of 3 minutes with a lighter Bunsen, its solubility, to what they have tried to break up (acting as solute) in a d isolvente polar (water) and one apolar (ether), and the degree of electrical conductivity and resistance to what has been used a rudimentary circuit that made passing an electric current through chemicals.
In short, the work has the aim of discovering and knowing the behavior of some common substances under different situations and their reactions.

INTRODUCTION:
No need to learn about the discoveries that have preceded us in the infinite axis of history, this we can deduce ... But what results will give us the use of ether, or by heating iodine? Well, we know that the result of practice depends on the type of chemicals we use, so let's take a look. We have here all sorts of substances: ion, forming strong bonds between the ions that form (NaCl / salt), covalent atomic, in which the atoms that form them create very strong networks crystal by sharing electrons (Cu / graphite), covalent molecular, representing discrete molecules linked by weak noncovalent forces (H2O / water I2/yodo) and metal whose atoms are linked by strong metallic bonds (Cu / copper). Only this we know that salt is solid at room temperature, conduct electricity only in liquid form, have high melting point and is soluble in water and insoluble in ether. Graphite differ from the salt is not soluble in any solvent or conduct electricity. Iodine and water have low melting points and boiling, dissolve in solvents same nature and do not conduct electricity (in its pure form). Copper is a great electrical conductor, it will not dissolve more than any other metal and hard to liquidificar.

EXPERIMENTAL WORK:

To measure the thermal stability we have used: -5
test tubes and a lighter without OLV idarnos of pliers to avoid burning wood.
To do this we heated in periods of 1 minute until a total of 3 minutes, and we have observed after one minute if still in their original state or changed. In the case of NaCl did not change during the three minutes we had it set to heat up. It was not the same with H2O that as time passed it was evaporating until finally there was nothing. In contrast, the iodine in the liquid state began just after a couple of seconds started to leave the tube a purple gas. The graphite did not suffer any change during the three minutes as copper.
For solubility measurements we used: -5
test tubes, distilled water, and ETE r.
start with the NaCl that was dissolved in water, but not in the ether. The H2O is not soluble in ether. Iodine is not dissolved in distilled water but in the ether. Graphite same thing happened to copper is not dissolved or in water or ether.
For electrical conductivity we needed:
- A circuit of a light bulb and a battery connected by wires and a watch glass.
By checking the conductivity of NaCl note that electricity does not transmit anything, but dissolution is a very good transmitting electricity flows without any problem. In the conductivity of H2O, compared to tap water with distilled water and found that tap water is a good talker but q ue distilled water does not conduct electricity.
elements we used were:
v 10 test tubes racks

v v clamp wood burner

v v v
bulbs bulbs
Stands Battery pouch v 4.5V
v v
Cables nails

RESULTS:

Part of the results and we have had in the previous point, so it will be something not far short of what would be in in ICIO.
To do something more bearable as you summarize in a draw, but the comments did not deliver you one:
THERMAL STABILITY
Well, the comments of this part of the practice: In
NaCl was not observed any change in the whole process of experimentation with the lighter. In distilled water the change we see is that over exposure to heat every minute until it evaporates at 3 min, evaporates completely. In the iodine we see that nothing put into the burner comes a purple gas that smells rather strong. Both the graphite and copper not suffer any change. SOLUBILITY

solubility of NaCl in the note that is dissolved in water but not in the ether does not dissolve. The water with ether produced a precipitate, ie the iodine is below and above the ether as with the water and oil. Iodine is dissolved only in a fraction and has stained the water but rather with ether is dissolved completely. Graphite is not dissolved in water or ether as copper. Water with the ether does not dissolve settling occurs because it is denser (the water stays down and the ether above) as is the case with oil. Electrical conductivity

The only thing more interesting is that in salt water is conductive, and bubbles due to oxidation, but salt alone does not also Interestingly non tap water is conductive and bubbles due to oxidation, whereas the distilled water does not conduct electricity. Instead we used benzene pentane. Copper is clear that it is a good conductor because it is used to make power lines.

These tables show the data we collected during the experiment. Is too small, so it would be advisable to click to read what they say.

QUESTIONS:

1. Identifies what type of substances belong compounds with which you worked.
NaCl: Ionic. Water: Covalent molecular. Iodine: Covalent molecular. C (graphite): Covalent atomic. Cu: Metallic.
2. What kind of bonds hold them together to keep them in their natural state?
NaCl: Ionic bond. Water: The covalent bond. Iodine covalent bond. C (graphite) lattice. Cu: Metallic bond.
3. What relationship exists between the forces that hold them together and boiling and melting points?
The higher boiling point and melting of a substance, the stronger the force that held together. In the case of water, for example, which has a covalent bond (Weak force), boils and melt at low temperatures. Salt, on the other hand, being an ionic substance (much stronger), have melting and boiling points too high.
4. In view of the results, what is the substance whose molecular bonds are weaker?
Obviously, iodine, and that even goes through a melting point prior to sublimate (go from solid to gas).
5. What kind of substances belong HCl and pentane (benzene)?
are covalent molecular substances with covalent bonds. These substances share properties in varying degrees, with water and iodine.
6. What kind of substances are dissolved in water (polar solvent)?
ionic substances such as NaCl and polar molecular covalent substances such as water.
7. What kind of substances are dissolved in ether (nonpolar solvent)?
molecular nonpolar covalent substances such as iodine.
8. With their experience, indicating that fluids are immiscible. We
immiscible liquids that we used in our experiment are ether and iodine. After the liquids are immiscible higher density.
9. What kind of substances do not dissolve in either polar solvents or nonpolar?
have not been dissolved or graphite or copper in water or ether, and are atomic covalent and metallic substances.
10. Does NaCl always leads electricity?
is because not only the lead dissolved in water alone does not drive, nor have seen in other situations, but still only the NaCl does not lead, it does not conduct electricity provided.
11. Why tap water has some electrical conductivity and not distilled water?
Because water tap water has minerals that conduct electricity whereas distilled water is simply H2O with nothing more, no minerals or anything.
12. What is the substance which has a higher conductivity? What kind of substance belongs?
The substance of our experiment shows is that more conductivity copper, ie a metal, so we conclude that substances with higher conductivity are metals.
13. Whether the intensity of the bulb increases or decreases when you add NaCl to water.
increases because distilled water is not conductive by itself and not salt, but the two together if they are, then if you add NaCl, the intensity of the bulb increases.
14. When you add a drop of iodine solution in the test tube containing water and ether. Where the iodine was dissolved in water or in the ether?
Well, considering that the iodine will not dissolve in water, we assume it will be dissolved into the ether because it is a yes apolar solvent that can dissolve the iodine.

CONCLUSIONS:
knew beforehand, but not in depth, the possible results of our experiment, thanks to our knowledge of physics, chemistry and history scientists and their discoveries. For example, there were certain things that virtually anyone with minimal scientific culture could have deduced (although, of course, many do not): that the water would evaporate to reach 100 º C, the salt is dissolved in water or copper I would not. To find the rest could proceed in two ways: first, find the results of our questions posed to the air in our books (which probably ended after a little mental exercise, giving us the answer), the second and most convincing , especially for those who would not read a science book unless the barrel of a I was pointing gun (figuratively, such as the gun of the suspense in Physics), make our own experiments.
And so it has been, leading to a (perdónesenos alliteration) experimental experience, we managed to reach the goals that we had originally proposed. We now know, with recourse only to our memories, how they react to different types of substances to be subject to the conditions described above, having used both ways to find out. And, yes, we won a small prize in this long career: the satisfaction of seeing our experiments, like many others in years past, have achieved the expected results, we can now collect.

BIBLIOGRAPHY:

For the experimental work and the results obtained has not been necessary to consult any encyclopedia or web page, because it was the work we have done in class. All we needed were our own books in Physics and Chemistry, and the booklet.

ACKNOWLEDGEMENTS
assume that we must thank our professor of physics and chemistry, Angel. And, of course, all made possible by scientific knowledge we have today.

Haizea Muñoz Cristina Morillas and

0 comments:

Post a Comment