Tuesday, February 24, 2009

How Much Does A Baby Platypus Cost

6: uniform linear motion




We are back to the lab again, but this was the test or experiment with uniform rectilinear motion. Scientists say they do not exist, others say it is a perfect example of the car. We in the laboratory does not have the best conditions for a linear motion, such as a vacuum where there is no friction. With everything and it got to do a similar move.



This is achieved with:






  • a kind of strip.



  • support






  • clay one meter



  • a stopwatch



  • a large steel ball



  • a small steel ball



The strip we use to give the same initial velocity of the ball, stand to mantain the same angle all the time, the clay to attach the strip to the table support and also to mark the various actions that must travel ball meter to measure the distances to go, the stopwatch to measure the time and finally the steel balls act as mobile.




With each ball took about three times each in the various Medici, put four separate measures: 1.20 m, 1m, 0.50 m and 0.30 m. Then find the average time in each of the distances and average speed which was mobile.




results:




These are going to present in a data table and graph, which will be discussed later.


These are tables of data that we take for experiments with the large ball and small ball, respectively. They appear in the same colors as the representation of those data in the graph.



Here is the graph, which shows the average time it took each ball to travel 0.3, 0.5, 1 and 1.2 meters.

The slope of the graphs match the average speed for each point, if taken from that point and the origin of coordinates, coincides with the average speed for the entire route, if you get to measure it in the very straight ( without taking into account the deviations that each point holds.)



There is a slight deviation between the two lines, due to measurement errors, to friction or other problems. However, we consider that this deviation is negligible, since it is due to the slowdown of the ball by friction on the table and small errors when taking measurements, so you could say that the mass of the moving object does not affect the speed you get (since the masses of the two ball were very different.)



The graph represents a movement, but with small irregularities, which could be described as rectilinear and uniform (provided you ignore the deviations, of course). Friction is the cause of many of these irregularities, causing the stalling mobile as you go road.

Then our teacher asked us what would happen to the graph if the distance was too great. Well then this answer would need many more seconds to cross it, increase the time needed, the friction produced by the surface would also increase, so that eventually the steel ball would eventually stop.

then asked us to elaborate a hypothesis about the momentum as we observed in practice. And here is our scenario: A cell phone can not maintain a constant speed and stops when it has been a time of change of rest to motion, only are cases in which takes a constant speed in a dende no friction. An example at hand and closer to the space in a car driving at a constant speed on a flat road and straight, thus a uniform rectilinear motion as anti-friction and not restrained Unless your foot off the accelerator.

Tuesday, February 10, 2009

Spider Bade- Misty Mundae 5

Lesson 5: A walk in the cole

INTRODUCTION

This is our last practice, this is physical, since we have begun to study in this evaluation, we have started with the basics which is the movement of cuerpor , including vectors and more items you will see later. We have done in college sports. SUMMARY


When we got to the lab, the first thing we did is to welcome the physics, the teacher first told us about the parallax angle deviation of the apparent position of an object, depending on the chosen viewpoint. Put us all against the back wall and the slate put some pictures, I will put these to the comprobeis:


put something away from the computer screen and thumb of the left hand cover one of the points, Wink your right eye and will see what happens ... repeat right hand and left eye. Not so, right? After this we explained what it was the practice, as all was ready we went down to sports to count steps according to this scheme as you lest you pesdais detail:


are made in the image means that we counting equal steps, or at least they were trying to. Rojan lines indicate the path we take to count steps, ovement vectors are different, ranging from A to B, B to C, C to D, D to E and E back to A, all directly without surround the field. CONCLUSIONS

This practice has helped us to distinguish between certain concepts very basic physics, such as displacement, trajectory, distance, etc. Later we will see the definition of these concepts.

ISSUES 1. Path: All the places I passed a mobile.

Reference System: A set of points that are used to measure physical quantities. The cardinal points are used in a map to locate places. Therefore it is a reference system.

Displacement: It is what has moved a mobile, ie the resulting vector of final minus initial position.

Position: point at which an object is at any given time.

Distance: Measure the distance between two bodies.

I hope that with these definitions, everything is much clearer ...

2. And drew a chart with all the points that follow from the reference system which is the point A (the cretro the field).

3. Only the displacement coincides with the distance in points: from A to B and from C to D.

BLIBLIOGRAFIA

I helped a little with wikipedia and images, which makes everything a little more faciel to explain.

This practice has made Cristina Morillas.