Tuesday, April 21, 2009

Gc Tooth Mousse Exp Date

Lesson 7: The Tirolina





PRACTICE 7 - the zip line







This practice has been conducted to analyze rectulĂ­neo uniformly accelerated motion (MRUA). Our teacher told us that this experiment would make a more or less reliable representation of what happened in this kind of movement. It is called the zip because is a nylon thread attached to a support and to the table so that there was enough to appreciate outstanding acceleration. Instead of slipping a person for the zip line, replace it with nuts of different sizes were 2, one larger than the other. While the size did not influence at all in its speed and therefore its acceleration. The middle wire about 2.5 m and divided into sections of 20cm, each of these sections both times we take the large nut and the small. This process was done 5 times on each screw to reduce the possibility of error and have more data with which to work to see if it really is the movement we seek. In summary we have used materials are:













  • nylon







  • nuts of different sizes







  • lubricant (in case you do not slide well)






  • timer







  • meters






  • permanent marker.






The first thing was to build the zip line and take measurements of the distances to the distances that nuts should go. After that everything was taking time.

Here is the table that the measures taken in practice.














Questions:







1. This is because we know that this movement is a MRUA, ie moving along a straight line and that its acceleration is a constant vector, so, if we plot the velocity-time we have a line. However, the speed changes in proportion, so at the same time interval the velocity increases in the same way: that is, a straight line.








2.How we have made practice with two nuts of different size and weight we can say with certainty that, taking into account that the difference was not large, the difference in speed and time to reach the same positions are very small, we imagine that the larger the difference in weight and size the greater the difference in speed and timing.







3. if you use other angles for the wire may be more or less quickly. the more inclined you will go faster, so the less inclined you have, say, the horizontal is more slowly descend. therefore reach lower speeds.







4. if the thread had been vertical would have been a free fall as it drops the nut without give any initial velocity. as if from the top of a building you drop a ball of paper.







5. to descend on the nut thread is required to be tight, so that if the movement will remain rapid and uniform would be in doubt if the line tight without movement would remain the same. We think not, since there would be "obstacles" (when a thread is not tense up as small wrinkles) that would slow even as we have not proven they can not ensure say that this is just a hypothesis.











0 comments:

Post a Comment